International Journal of Mining and Geo-Engineering

International Journal of Mining and Geo-Engineering

Development and pilot-scale testing of a borehole structure for directing blast energy to reduce seismic forces on quarry elements

Document Type : Research Paper

Authors
1 Department of Mining work, Tashkent University, Republic of Uzbekistan.
2 Department of Geology and Geophysics of Oil and Gas Fields, Tashkent University, Republic of Uzbekistan.
3 Satbayev University, Department of Mining, Almaty, Republic of Kazakhstan.
4 Institute of Seismology, Mavlonov Academy of Sciences , Laboratory of Instrumental Seismology and Seismometry, Tashkent, Republic of Uzbekistan.
10.22059/ijmge.2026.409124.595352
Abstract
Open-pit mining plays a crucial role in the mining industry of Uzbekistan, where drilling and blasting remain the primary rock fragmentation method. As quarry depths increase, the seismic effects induced by blasting—particularly shock waves and stress redistribution—pose significant risks to the stability of quarry slopes, benches, and haul roads, potentially leading to cracking, deformation, and slope failures. Controlling blast-induced seismic forces therefore represents a critical engineering challenge in deep open-pit operations.
This study proposes a new borehole charge structure designed to direct blast energy in a controlled manner, thereby minimizing seismic forces acting on sensitive quarry elements. The proposed approach is based on introducing an asymmetric geometric modification inside the borehole charge, enabling preferential energy focusing toward a predefined direction rather than uniform radial propagation. Unlike conventional shaped-charge technologies that generate high-velocity jets concentrated at a single point [1; 2], the developed borehole structure redirects blast energy over a wider angular sector, enhancing rock fragmentation in the target zone while reducing seismic impact on the protected side. A pilot-scale field experiments were conducted in a limestone quarry to evaluate the performance of the proposed borehole charge design. The seismic response generated by blasting in the experiments was recorded using ETNA-2 accelerometers. The same type of seismic instrument (ETNA-2) was used as a standard for all tests.
The experimental results demonstrated that the directional structure installed within the borehole charge significantly reduced the dynamic effects of blast-induced seismic stresses in the protected sector where the structure was positioned. This reduction was experimentally verified through a comparison of seismic recordings obtained from the directional-charge configuration and those obtained from a conventional cylindrical borehole charge.
The overall results of the conducted experiments were ultimately evaluated in terms of seismic intensity values. For all tests involving the borehole charge equipped with the directional structure, the seismic impact recorded at a distance of 30 m exhibited the highest intensity in the northern sector (I = 8.09), whereas the lowest intensity was observed in the southern sector protected by the directional structure (I = 4.21). In contrast, for the conventional cylindrical borehole charge, the intensity values calculated from all blast tests at the same distance were nearly identical in all directions, with an average intensity of approximately I ≈ 6.3.
Using this new borehole charge design, the consumption of explosives is reduced by approximately 20–24%, which, from a cost perspective, makes the expenses incurred for the construction even lower than the cost of the saved explosives. The findings confirm that directional control of blast energy through borehole geometry modification is an effective and practical method for mitigating blast-induced seismic effects in open-pit quarries. The proposed borehole charge structure offers a cost-effective solution for improving operational safety and energy efficiency in blasting practices.
Keywords
Subjects


Articles in Press, Accepted Manuscript
Available Online from 16 November 2026