International Journal of Mining and Geo-Engineering

International Journal of Mining and Geo-Engineering

Durability Response of GGBS-RHA Geopolymers to Moisture Cycling

Document Type : Reply to comment on Paper

Authors
1 MNIT,JAIPUR
2 CIVIL ENGG. DEPTT, NIT, KURUKSHETRA, HARYANA, INDIA
3 MNIT, Jaipur Rajasthan
10.22059/ijmge.2026.403101.595308
Abstract
The influence of thermal curing conditions on the durability of geopolymers made from ground granulated blast furnace slag (GGBS) and rice husk ash (RHA) and subjected to wetting–drying cycles was examined in this study. Two waste materials otherwise destined for landfill, GGBS and RHA, were used as precursors for the sustainable production of geopolymer binders, and geopolymerization was initiated by an alkaline activator prepared from sodium hydroxide (NaOH) and sodium silicate (Na₂SiO₃). The GGBS-to-RHA proportions were varied at 30%, 50%, and 70%, and the Na₂SiO₃/NaOH ratios were set at 0.5, 1, and 2. The binders were cured for seven days under three thermal conditions, namely ambient temperature (27°C), 45°C, and 90°C, before their durability was assessed through twelve wetting–drying cycles in accordance with IS 4332 (Part IV)-1968. The loss in strength was found to decrease as the curing temperature rose up to 45°C and to increase again as the temperature approached 90°C. Strength loss was also reduced when the RHA content and the activator ratio were raised, because the calcium-rich GGBS and silica-rich RHA promoted the rapid formation of C-S-H and C-A-S-H gels and an early gain in strength, while the mass loss followed a trend comparable with that of the strength loss. Specimens cured at 45°C for seven days showed the best durability, and both their residual strength and their weight loss satisfied the Indian Road Congress limits for subgrade and sub-base materials. The incorporation of calcium-rich GGBS into an RHA-based geopolymer is a relatively unexplored area, and the results indicate that the resulting binder is stronger and more durable than the values required by Indian standards, which makes it suitable for the construction of road subgrades.
Keywords
Subjects


Articles in Press, Accepted Manuscript
Available Online from 16 November 2026